FAQ - HW / HS Series

HW / HS Series

[Q0396]
・For the surface mounting DIP type HW series, where is No.1 pin?
A.
・Because the hall element can maintain characteristics within the specified range even if it turns by 180°, the upper right pin is No. 1 pin for the surface mounting type and the upper left pin is No. 1 pin for the DIP type.
Was it helpful?
Yes
No
Thank you We will reflect your opinion on the improvement of the web content.
[Q0397]
・How should we specify the sensitivity rank when ordering HW series hall elements?
A.
・Specify the sensitivity rank 3 or above for the design using ultra-sensitive type HW series hall elements.
Ex) ABC, BCD, CDE, EFG ranks
Highly sensitive types HW-105C and HW-108C have the sensitivity rank QR only, and HS-0111 has no sensitivity rank.
Was it helpful?
Yes
No
Thank you We will reflect your opinion on the improvement of the web content.
[Q0398]
・How should we determine the value of the limiting resistor.
A.
・The resistor values of HW series and HS series hall elements drop quickly at high temperature. Therefore, they are easily subject to burnout and care should be taken of the drive circuit. In general, a resistor is added in series with the hall element to prevent burnout. Click here to see how to determine the resistor value.
Was it helpful?
Yes
No
Thank you We will reflect your opinion on the improvement of the web content.
[Q0399]
・Can we use it without the limiting resistor?
A.
・Yes, you can. However, the voltage and current are considerably reduced compared with those with limiting resistors. Click here for the details.
Was it helpful?
Yes
No
Thank you We will reflect your opinion on the improvement of the web content.